Update vzkernel newbie

From vpsget wiki
Jump to: navigation, search

Update only vzkernel on Centos. Read till the end before proceed.

Check the bootlist:

cat  /boot/grub/grub.conf

Proceed with update:

yum update vzkernel

Check the bootlis again and note that new kernel appeare to load at the next boot:

cat  /boot/grub/grub.conf

For any case count how much active vps now:

vzlist | wc -l

You may save the output in order to be able to compare it with the same command output after reboot/all vm start

vzlist | wc -l >/tmp/vzlist.txt
vzlist >>/tmp/vzlist.txt 



Once reboot finished take a look into /var/log/vzctl.log and /var/log/messages you may do it in two separte ssh sessions with tail -f command.

update vzctl vzquota ploop for better workaround.

    • NOTE** If you see messaged like this during module update:
 Cleanup    : vzkernel-2.6.32-042stab090.5.x86_64                                                                                                                                                                                           3/4 
dkms: removing: sysdig 0.1.84 (2.6.32-042stab090.5) (x86_64)
-------- Uninstall Beginning --------
Module:  sysdig
Version: 0.1.84
Kernel:  2.6.32-042stab090.5 (x86_64)
 Status: Before uninstall, this module version was ACTIVE on this kernel.
Removing any linked weak-modules
 - Uninstallation
  - Deleting from: /lib/modules/2.6.32-042stab090.5/extra/
  - Original module
  - No original module was found for this module on this kernel.
  - Use the dkms install command to reinstall any previous module version.
DKMS: uninstall completed.
Deleting module version: 0.1.84
completely from the DKMS tree.

Depending on your system config most likely you need to follow the instructions in the output message and try to install deprecated module manually after reboot. In general it should not be critical , however it depends on exact module. In the example we provided you may simply install sysdig in easy way: 1.Install kernel dev with the same version as your vzkernel. 2.Try to install sysdig package that will try to install sysdig-node kernel module. Otherwise you may find another solutions of module installiation.